Sree Ramraj Dyes & Chemicals

HD Xilicone is used to obtain high density effect on fabrics with soft hand feel with high elastic and without tack. Xilicone is heat resistant so on heat-press, the Xilicone does not melt and reduces the height . Xilicone is used as a very good anti-slip agent.  It can be print on Micro oven gloves, anti-slip mens socks and in baby socks.  HD print can be top-coated with glossy Xilicone as required. 

Mesh:

• 32 - 48T (80 -120 ), We normally prefer Nylon Mesh to prevent Air bubbles. As Polyester Mesh makes ink to stay, Nylon Makes Inks to flow In Manual Machine.

Squeegees:

• For optimum high density print effect, 65/90/65 shore triplet hardness squeegee is recommended

Curing Time:

• Cure Temperature:120 °Cfor 2 -3 mins

Mixing Ratio and Pot Life:

• Xilicone Can be mixed under 100 % with catalyst 2% and reducer 5 -10 %. It should be printed within 3-4 hours of mixing catalyst. Mixing Ratio and Pot life depends according to Temperature

It is Water Based Foam Screen Printing Inks, very soft and puff's on heat press and Curing. Direct Black foam is also available.

It is Silicone High Glossy Screen Printing Inks. Need to be printed with 2% catalyst. 

It is Anti Foil Gel Screen Printing Ink, used in place where foil is not needed to be printed. It needed to be printed as over coat. Anti Foil Paste is a printing base which is used to prevent Foil to be impressed on the print where the foil is not required. Anti-foil paste has a very soft touching effect. It can be printed as top base to the prints where the foil is not required, pigments can also be mixed and printed. 

Mesh:

• 43 cm (110 inches) Mesh 70 micron Silk 77 cm (200 inches) Mesh 48 micron Silk

Squeegees:

• Squeegees with 57-62 Shore "U" Type

Curing:

• For maximum fastness, prints are to be cure at 160C/320F. Airflow recommended is 1500 cfm/ 46cmm for 1.5 minutes.